Idiomas disponibles
Idiomas disponibles
Problem
Possible cause
The machine does
The battery ca-
not start.
pacity is low.
The bail switch is
defective.
The safety key is
not put in.
The machine cuts
The lawn is rough. Examine the mow-
grass unevenly.
The blade height is
not set correctly.
The machine does
Wet grass clip-
not mulch correct-
pings attach to the
ly.
deck.
The mulch plug is
missing.
The machine is
The grass is too
hard to push.
tall, or the blade
height is too low.
The grass catcher
and the blade
drags in thick
grass.
There is a high vi-
The blade is un-
bration in the ma-
balanced and
chine.
worn.
The motor shaft is
bent.
The machine stops
The blade height is
during mowing.
too low.
The battery pack is
out of power.
The grass clip-
pings attach to the
deck or the blade.
Operation temper-
ature of the ma-
chine is too high.
* If you cannot find the solution to these problems, go to the
service center.
English
7
Solution
Charge the battery
Voltage
pack.
No load speed
Replace the bail
switch.
Cut width
Put in the safety
Cut height
key.
Grass catcher ca-
pacity
ing area.
Weight (without
Adjust the blade/
battery pack)
cutting height to a
Measured sound
higher position.
pressure level
Wait until the
Guaranteed sound
grass dries before
power level
mowing.
Battery model
Install the mulch
plug.
Charger model
Increase the blade/
cutting height.
Vibration
IPX
Empty the grass
clippings from the
8
grass catcher.
(The full warranty terms and conditions can be found on
Replace the blade.
Greenworks webpage)
The Greenworks warranty is 3 years on the product, and 2
years on batteries (consumer/private usage) from the date of
1. Stop the mo-
purchase. This warranty covers manufacturing faults. A faulty
tor.
product under warranty might be either repaired or replaced.
A unit that has been misused or used in other ways then
2. Remove the
described in the owner's manual might be rejected for
safety key and
warranty. Normal wear, and wear parts are not considered as
battery pack.
warranty. The original manufacturer warranty is not affected
3. Inspect for
by any additional warranty offered by a dealer or retailer.
damage.
A faulty product must be returned to the point of purchase in
4. Repair the ma-
order to claim for warranty, together with the proof of
chine before
purchase (receipt).
you start it
again.
9
Increase the blade/
cutting height.
Charge the battery
Name and address of the manufacturer:
pack.
Name:
Remove the bat-
tery pack and
check the deck.
Address:
Cool the machine.
Name and address of the person authorised to compile the
technical file:
Name:
Address:
7
TECHNICAL DATA
40 V
3500 / min
410 mm
25 - 80 mm
50 L
18 kg
L
= 70,3 dB(A), K= 1,97 dB(A)
PA
L
= 92 dB(A)
WA.d
G40B2/G40B4/G40B25 and other BAF
series
G40C/G40UC4 and other CAF series
≤ 2,5 m/s², K=1,5 m/s²
IPX1
WARRANTY
EC DECLARATION OF
CONFORMITY
GLOBGRO AB
Globe Group Europe
Riggaregatan 53, 211 13 Malmö, Sweden
Micael Johansson
Riggaregatan 53, 211 13 Malmö, Sweden
EN
