Idiomas disponibles
Idiomas disponibles
EN
4.5
OPERATION TIPS
•
Do not try to override the operation of the start button or
bail switch.
•
Do not tilt the machine when you start it.
•
Do not put hands or feet near or below the turning parts.
•
Keep the discharge chute clean.
•
Do not cut wet grass.
•
Higher blade height is necessary for new or thick grass.
•
Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
5
MAINTENANCE
Remove the safety key and battery pack from the machine
before maintenance.
Keep the engine and battery pack free from grass, leaves or
too much grease.
Use only approved replacement parts.
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
Do not use strong solvents or detergents on the plastic
housing or components.
5.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the machine with a dry cloth. Do not use water.
5.2
LUBRICATION
Apply sufficient quantity of high grade lubricant to all
bearings. No more bearing lubrication is necessary in usual
operation conditions.
Do not lubricate the wheel components. Lubrication can
cause damage to the wheel components during operation.
WARNING
WARNING
CAUTION
CAUTION
CAUTION
WARNING
English
5.3
REPLACE THE BLADE
Figure 10.
Use only approved replacement blades.
Wear heavy gloves or wind cloth around the blade when
you touch the blade.
1. Stop the machine.
2. Make sure that the blade fully stops.
3. Remove the safety key and battery pack.
4. Turn the machine to its side.
5. Use a piece of wood to prevent the movement of the
blade.
6. Remove the mounting nut and spacer with a wrench or
socket.
7. Remove the blade.
8. Install the new blade. Make sure that the raised points
engage the hole(s) in the blade.
9. Put in the mounting nut and spacer and tighten them.
5.4
STORE THE MACHINE
•
Remove the safety key.
•
Remove the battery pack(s).
•
Clean the machine before storage.
•
Make sure the motor is not hot when you store the
machine.
•
Make sure that the machine does not have loose or
damaged parts. If it is necessary, follow these
instructions:
•
Replace the damaged parts.
•
Tighten the bolts.
•
Speak to a person at an approved service center.
•
Store the machine in a dry area.
•
Make sure that children cannot come near the machine.
6
TROUBLESHOOTING
Problem
The handle is not
in position.
6
WARNING
WARNING
Possible cause
Solution
The bolts are not
Adjust the height
engaged correctly.
of the handle and
make sure that the
knobs and bolts
are aligned cor-
rectly.
