Tabla de contenido
Idiomas disponibles
Idiomas disponibles
8.1
START THE MACHINE
1
2
1. Put in the safety key.
2. Push and hold the start button (2).
3. While you hold the start button, pull the bail switch (1) in
the direction of the handle bar.
4. Release the start button to start the machine.
8.2
STOP THE MACHINE
1. Release the bail switch to stop the machine.
WARNING
Wait until the blades fully stop before you start the machine
again. Do not quickly turn the machine off and on.
WARNING
Always remove the safety key and battery pack after you
complete the work.
8.3
OPERATE ON SLOPES
WARNING
Do not mow on the slopes with incline more than 15°. If
you are not comfortable, do not mow on a slope.
•
Do not go up and down on a slope, mow across the face
of the slope. Be careful when you change the direction on
a slope.
English (Original Instructions)
11
•
Monitor the holes, ruts, rocks, and other hidden objects
that can cause you to fall. Remove all obstacles such as
rocks and tree limbs.
•
Make sure that your footing is stable. If you are out of
balance, release the bail switch immediately.
•
Do not mow near drop-offs, ditches, or embankments.
8.4
OPERATION TIPS
•
Do not try to override the operation of the start button or
bail switch.
•
Do not tilt the machine when you start it.
•
Do not put hands or feet near or below the turning parts.
•
Keep the discharge chute clean.
•
Do not cut wet grass.
•
Higher blade height is necessary for new or thick grass.
•
Clean the bottom of the mower deck after each use.
Remove grass clippings, leaves, dirt, and other debris.
9
MAINTENANCE
WARNING
Remove the safety key and battery pack(s) from the
machine before maintenance.
WARNING
Keep the motor and battery pack(s) free from grass, leaves
or too much grease.
CAUTION
Use only approved replacement parts.
CAUTION
Do not let brake fluids, gasoline, petroleum-based materials
touch the plastic parts. Chemicals can cause damage to the
plastic, and make the plastic unserviceable.
CAUTION
Do not use strong solvents or detergents on the plastic
housing or components.
NOTE
Recommended tightening torque (blade): 33-37 Nm.
9.1
GENERAL MAINTENANCE
•
Before each use, examine the machine for damaged,
missing, or loose parts such as screws, nuts, bolts and
caps.
•
Tighten correctly all the fasteners and caps.
•
Clean the machine with a dry cloth. Do not use water.
EN
Tabla de contenido
Solución de problemas
