Idiomas disponibles
Idiomas disponibles
INSTALLATION
7 INSTALLATION
!
C A U T I O N
•
Transport the products as close as possible to the place to be installed
before unpacking.
•
Do not put any material on the product.
!
D A N G E R
•
Install the device with enough clearance and space around it
for operation and maintenance.
Install the Remote control box where good ventilation is
available
•
Do not install the Remote control box where there is a high level
of oil mist, salty air or sulphurous atmosphere.
•
Install the unit as far as practical (being at least 3 meters) from
electromagnetic wave radiator (such as medical equipment).
•
For cleaning, use noninflammable and nontoxic cleaning liquid.
Use of inflammable agent should cause explosion or fire.
7.1 FIX THE UNIT TO THE WALL
The YUTAKI M Remote control box is a simple-to-install device.
To make this operation even simpler, the YUTAKI Remote
control box disposes of 4 key slots to ease the operation of
fixing of the Remote control box to a wall.
!
C A U T I O N
Place the unit on a resistant wall
7.1.1 Dimensional for the installation to a wall
Ø6
Ø 11
11
4
PMML0603 rev.0 - 02/2023 - 1000014074
330.4
11
•
Work with sufficient ventilation. Working in an enclosed space
should cause oxygen deficiency. Toxic gas should be produced
when cleaning agent is heated to high temperature by, e.g.,
being exposed to fire.
•
Cleaning liquid shall be collected after cleaning.
•
Pay attention not to clamp cables when attaching the service
cover to avoid electric shock or fire.
!
C A U T I O N
•
Install the device in the shade or not exposed to direct sunshine or
direct radiation from high temperature heat source.
•
The device installation and connections must be performed by
qualified professionals and following the local directives.
•
Check to ensure that the field supplied electrical components
(mains power switches, circuit breakers, wires, connectors and wire
terminals) have been properly selected according to the electrical
data indicated on this document and they comply with national and
local codes. If it is necessary, contact with your local authority in
regards to standards, rules, regulations, etc.
7.1.2 Notes for installation
The Remote control box is designed in a way that wiring must
be route through the bottom side of the unit. Rubber bushing
have been placed for such purpose. After routing the cables
through the rubber bushing, the cables should be placed in a
simple manner inside the Electrical box, so the identification
should be easy and at first sight. Additionally, cables should be
fixed to the plastic cord located inside the Electrical box, before
the TB1
Rubber bushing for power
supply wiring routing
Rubber bushing for
control wiring routing (x2)
