Idiomas disponibles
Idiomas disponibles
10.3 Setting open time / permanent deadbolt lock operation
Tag-it ™ISO
Prerequisites:
1. Hold the programming key card in front of the
antenna.
Acoustic signal is heard. LED illuminates
green.
x
3. Hold the clearing key card in front of the
antenna again.
An acoustic signal is heard at one second
intervals.
The LED flashes in green in parallel to the
acoustic signal every second (max. 30 sec).
The open time can be adjusted at any time, and is also retained after a power supply
interruption or a simple reset.
The open time can be extended beyond 30 sec. with the MDU 110 using a special
function or a macro (
After a complete reset or setting the door terminal to "permanent deadbolt lock
operation", the set opening time is cleared and the factory setting of 3 sec or deadbolt
lock operation are activated.
If the clearing key card is held out only briefly (< 1 sec.), the terminal switches to
permanent deadbolt lock mode. With the presence of an authorised user key, the
terminal changes its locking status (permanently open or permanently closed).
If permanent deadbolt lock operation is no longer required, an open time must be set.
Programming key card
2. Hold the clearing key card in front of the
antenna.
1x/s
1x/s
4. Remove clearing key card after the required
time.
Macros, page 46).
Tag-it ™ISO
Clearing key card
x
x
Acoustic signal is heard. The LED flashes
quickly in green.
The LED illuminates permanently in red.
The open time is set for all locks and
authorised user keys.
57
