hafele WT 300 Manual De Instrucciones página 47

7. Commissioning
The system is supplied in simple operation mode for stand-alone operation (SA).
This document describes the commissioning process for stand-alone operation only.
Stand-alone operation will be permanently shut off once the product is configured for the first
time using the MDU 110 mobile data transfer unit. After that, reactivating this operation mode
is only possible after a complete reset,
Commissioning details for using the device with Dialock software applications can be found in
the Dialock software documentation.
Commissioning starts automatically after switching on the power supply.
For safety reasons, the initial start-up can only take place within 5 seconds after the
power supply was switched on.
• Read through the steps carefully before commissioning.
• Have both master keys ("green" programming key and "red" erasing key) at the
ready before start-up commences.
• Perform the work operations quickly and without interruptions.
If the commissioning time window is exceeded:
1. Disconnect the power supply.
2. Wait until the LED goes out.
3. Restart the commissioning process.
Alternatively, commissioning can also be started by a simple reset (
reset, page 60).
Recommendation: Carry out a firmware update with the MDU 110 mobile data transfer
unit before commissioning to ensure that the most up-to-date DIALOCK firmware is
on the terminal.

13.2 Complete reset, page 60
.
13.1 Simple

47