Metabo TDP 7501 S Manual Original página 11

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 61
Do not buckle, squeeze, drag or drive over
power cable or extension cables; protect
from sharp edges, oil and heat.
Place extension cable so that it can not get
into the fluid to be pumped.
Always unplug before servicing the pump.
B
Risk of electric shock from pump
faults!
Before each use check the equipment, espe-
cially the power and extension cables, power
plug and float switch for possible damage.
Risk of fatal electric shock!
Do not attempt to repair the pump yourself!
When repaired inexpertly there is a hazard of
liquid entering the electrical parts of the
pump.
A
Caution!
To avoid water damage, e.g. flooded
rooms, caused by pump malfunctions or
defects:
provide for suitable safety measures such
as the following:
– alarm or
– collection tank with monitoring.
The manufacturer is not liable for any dam-
age caused by:
– improper use of the pump;
– overloading of the pump through conti-
nous operation;
– failure to operate and store the pump in a
frost-free environment;
– unauthorised modification of the pump (re-
pairs to electrical equipment may only be
carried out by qualified electricians!);
– use of spare parts which have not been
tested and approved by the manufacturer;
or
– use of unsuitable installation materials (fit-
tings, connection lines etc.).
Suitable installation materials:
– pressure-resistant (min. 10 bar)
– heat-resistant (min. 100°C).
4.
Assembly and Installation
4.1
Connecting the discharge line
9
1. For selection of the largest discharge line
diameter:
cut the smaller (9) attachment off the mul-
ti-adapter.
3
Note:
The best pump capacity is achieved through
selection of the largest discharge line diame-
ter.
2. Place the non-return valve (11) in the dis-
charge port (12). The non-return valve
must open in the direction of the arrow (la-
bel 'UP' on the non-return valve must point
to the multi-adapter).
3. Screw the multi-adapter (10) on to the dis-
charge port (12).
4. Slide the discharge line over the multi-
adapter (10) and secure with a hose
clamp.
ENGLISH
¾"
G ¾"
1"
G 1"
10
11
12
11
loading