VM R750EU6 Manual De Instrucciones página 114

INJECTION SYSTEM: this procedure
must be carried out together with the
lubrication system protection proce-
dure.
GB
• Make sure there are no deposits or
sediments in the fuel tank.
• Prepare a mixture of diesel fuel com-
plying with the DIN EN 590 specifica-
tions, and Petronas DIESEL TMF PLUS
additive. The ratio must be at least
1:400 (1 litre of additive to 400 litres of
fuel). If you use Biodiesel (complying
with the UNI EN 14214 specifications),
it must be mixed with diesel fuel up to
7%;
VM Motori, however, recommends the
use of diesel without Biodiesel.
The use of any other fuel is forbidden.
• Fill the tank with this fuel mixture.
• Where relevant, check there is no
interference between the radiator fan
blades and the relative air duct.
Start up the engine and run it until it
reaches the right temperature for wa-
ter-cooled engines (about 70°- 80°C).
• Drain the fuel tank.
• Check for any fluid leakage (and
make any necessary repairs).
• Switch off the engine and wait for it to
cool down.
• Check for any fluid leakage (and
make any necessary repairs).
• Switch off the engine and wait for it to
cool down.
• Disconnect the engine from all the
components used for the test
English
R750EU6 - TE4 - IE4 - ISE4
3) STORAGE CONDITIONS
- Engines on pallets
After applying the anticorrosion
protection, the engine must be placed
in a dry, well-ventilated environment
and adequately covered. The covering
must be applied in such a way that air
can circulate around the engine, pre-
venting the formation of condensation.
- Engines on vehicles
The vehicle must be stored so as to mi-
nimise exposure to atmospheric agents
START-UP
- Engines on pallets
Remove the covers and protective
elements applied to the engine open-
ings (for instance, air suction ducts
or turbocharger air inlet, exhaust gas
ducts or turbocharger guard).
Check there is no damage to the ex-
ternal engine components; make any
necessary repairs.
Clean the throats of the metal belt pul-
leys, using a suitable solvent. Install
the service belts
Check the rubber tubes and manifolds
are in good condition, and check the
tightening of the relative fixing clips; if
they are damaged, replace them.
38 2056G