Grundfos AMG Serie Instrucciones De Instalación Y Funcionamiento página 14

7. Remove the insulator and the turnable metal part
by removing the centre screw (pos. A in fig.
Installing a mixer) and the two fixation screws
(pos. B in fig. Installing a
A
C
Fixation
Pos. Description
A, B Bolts
C Insulator
2 Column profile
3 Depth blocker
31 Hole for fastening a safety wire
8. Adapt the outside of the square insulator to the
inside of the column profile. The insulator must fit
tightly inside the column profile.
9. Insert the column profile into the bottom fixation
bracket, and mount the top end with the insulator
and the turnable metal part on the already
14
mixer).
31
B
2
3
installed top fixation bracket. Tighten the three
screws (pos. A and B in fig.
the desired position. It is possible to adjust the
angle in steps of 7.5 °.
10. If an intermediate fixation bracket (pos. 19 in fig.
Installation of an AMG mixer) is used, fit it to the
turnable part welded on to the column profile in
step 6. Drill holes in the tank wall, fit screws in the
bracket and tighten the screws.
11. Fasten the depth blocker (pos. 3 in fig. Installation
of an AMG mixer) in the right position.
12. Drill the holes for the mounting screws of the
crane foot (pos. 12 in fig. Installation of an AMG
mixer) in the concrete.
13. Mount the crane foot, then fit and tighten the
screws.
14. Mount the lifting wire (pos. 15 in fig. Installation of
an AMG mixer) on the motor bracket using the
shackle.
15. Mount the top end of the safety wire to the hole
(pos. 31 in fig. Installing a
bracket using a shackle. The other end of the
safety wire ends in a shackle through which the
lifting wire must run. See fig.
Installing a mixer.
Safety wire
Installing a mixer) in
mixer) of the top fixation
Installing a mixer and
15