Set the distribution mode
Set the mode used for distributing when calculating charges.
There are two methods for distribution.
Time distribution: This method calculates distribution ratios based on the operating times of the indoor
units (thermostat ON cumulative time and thermostat OFF cumulative time).
Load distribution: This method calculates distribution ratios based on the electricity/gas usage (including
standby power) of the indoor units and outdoor units.
1
Touch [System Settings] in "Settings".
The "System settings" screen is displayed.
z
1
2
Touch [Distribution mode settings].
Enter the identification number (password level 1 or 2) and
z
the "Distribution mode settings" screen is displayed.
3
Change the settings.
2
Item
Distribution
Set the distribution mode (time distribution or
modes
load distribution).
y Load distribution is not available for "Hybrid
GHP/EHP".
GasDist/PwGn
Select whether to calculate distributions when
using gas for power generation.
y When set to "No", you cannot set charge each
area and billing method.
Charge each
Select whether to use charge each area for gas
area
power generation.
y When set to "No", you cannot set billing
method.
Billing method
Set the billing method for gas power generation.
Energy savng
Set the range of energy savings effects for multi-
dist
function air conditioners or ice thermal storage
models in calculations for distribution. (when load
distribution only)
y With "O/D system", only the air conditioning
distribution of the area of the outdoor system
is reflected.
y With "DistrGrp", the air conditioning
distribution of all areas in the entire distribution
group is reflected.
PwrDistr calc trgt Set the target of electricity distribution
calculation.
y "OpertnTime" is distributed between the
electricity for both outdoor units and indoor
units.
y "T/S ONTime" is distributed to the electricity
for only outdoor units.
4
Touch [Register].
To cancel the settings, touch [Cancel].
z
Explanation
4
27
