Idiomas disponibles
Idiomas disponibles
Display and keyboard
There are two main function modes:
RUN and PRO. PRO mode is when
configuration menu is entered to
programm
the
indicator,
RUN is the normal mode in which
display shows the reading according
to configuration and input signal
value.
The table below summarizes display
parts
description
and
keyboard function.
1
4 red digit Display
2
Minus sign LED (only for JR-P)
3
Keyboard
4
Setpoint 1 LED
5
UP key
6
SHIFT key
7
DATA/ENTER key
8
Setpoint 2 LED
9
Free space for units label
Installing and connecting recommendations
WARNING: If this instrument is not installed and used in accordance with this instructions,
the protection provided by it against hazards may be impaired.
To meet the requirements of EN 61010-1 standard, where the unit is permanently connected to main
supply, its is obligatory to install a circuit breaking device easy reachable to the operator and clearly
marked as the disconnecting device.
To guarantee electromagnetic compatibility, the following guidelines should be kept in mind:
•
Power supply wires should be separatedly routed from signal wires and never runned in the same
conduit.
•
Use shielded cable for signal wiring.
•
Cables section should be 0.25 mm².
Before connecting signal wires, signal type and input range should be verified to be within the right
limits. Do not connect simultaneously more than one input signal to the meter.
SERIE KOSMOS
whereas
2
3
LEDs
and
RUN MODE
Shows value according configuration.
It iluminates for negative readings.
—
It iluminates when Setpoint 1 turns active.
Display TARE.
TARE RESET (when pressing more than 3s).
Displays maximum and minimum stored values.
After 5s of pressing, sets maximum and/or minimum
memorized value to current display value.
Changes to PRO mode.
It iluminates when Setpoint 2 turns active.
—
www.ditel.es
JR-C / JR20-C
UP
SHIFT
DATA
1
ENTER
4
5
6
7
PRO MODE
Shows steps and data during configuration.
It iluminates for negative values.
It iluminates when Setpoint 1 turns active.
Shows Setpoints value.
Increases value of active digit.
Shifts active digit to the next right digit.
Shows sequentially menu options.
Validates selected data and parameters.
Moves one step forward in configuration menu.
Changes to RUN mode.
It iluminates when Setpoint 2 turns active.
1
2
9
8
—
—
49
