Installing And Removing The Thread-Tapping Head Into And Out Of The Bed Carriage; Changing The Thread Size F; Tapping Threads G - Rothenberger SUPERTRONIC 2 SE Instrucciones De Uso

 Insert the thread jaws with the same number as on the respective thread-tapping head and
make sure it engages audibly.
 Ensure that the numbers on the thread-tapping head and on the thread jaws are on the same
side.
Precise thread-tapping is only possible if the number on the slot of the thread-
tapping head corresponds with the number on the thread jaw!
5.5 Installing and removing the thread-tapping head into and out of the bed
carriage
 Lift the thread-tapping head to half height.
 Bring the thread-tapping head into the diagonal position and remove it.
 Not until the thread-tapping head is in a parallel position to the flat side of the thread-
tapping pin can it be removed from or installed in the machine.
5.6 Changing the thread size
Automatic thread-tapping head:
 Ensure that the thread-tapping head is on the tool carriage and that the thread jaws
correspond to the thread size.
 Insert the selector pin into the selector block with the necessary thread size.
 The size is shown on the respective selector block.
Use the silver selector pin and the block for ½"- 1" and the black selector pins for ¼"- 2"
For the standard thread-tapping head:
 After releasing the pipe cutter, the cradle can be moved up and down.
 Balance the reading-off device on the cradlev (1) with the defined measuring division on the
scale plate (2).
5.7 Tapping threads
 If there is a dangerous situation, press the safety pedal right down. This stops the machine.
 To restart the machine, press the release button on the side of the safety pedal.
To guarantee precisely ground threads, follow the instructions below:
Use only raw material that is in perfect condition for tapping threads.
If you use deformed and / or pipes cut off at an angle, it is not possible to tap threads that
conform to the relevant standards!
Use the thread-tapping head and the corresponding thread-tapping jaws that match the
thread size! Secure the thread-tapping head correctly on the tool carriage.
Do not place the thread-tapping head directly and unprotected on the floor and handle it
with care! Ensure that the thread-tapping oil runs on the thread-tapping jaws!
30
Thread-tapping
head
ENGLISH
Tapping head pin
F
G