Idiomas disponibles
Idiomas disponibles
9.1 REPLACING A DAMAGED BLADE.
The blade is one of the most important elements of a masonry saw. A good blade is fundamental to get an
optimal performance of the machine. Replace it when damaged or blunt.
Never use any blade that is not adequate for the material to cut and make sure it has the required
characteristics: maximal diameter, inner diameter and maximal supported revolutions.
Take into account that within the group of diamond blades there are different types depending on the material
to be cut; always choose the most appropriate disc for your case.
For all the above, we recommend that you always use ORIGINAL SIMA BLADES that meet the technical and
safety requirements demanded and are offered in a wide range that covers all needs and that facilitates the correct
choice.
9.2 ALIGNING THE BLADE WITH SLIDES.
The masonry saws MAGNUM 700L and 1000L are perfectly reviewed and tested in the factory before delivery.
If for any reason the blade is not aligned with the slide of the cutting head, you need to realign anew.
Blade and slides need to trace identical lines or parallel planes.
If you need to align the blade with the slides, you need to loosen the supports in the cutting, where the blade
shaft is holding and orient it until the blade is parallel with the line traced by the slides and tighten the supports
screws.
The supports of the cutting head are flexible and allow correcting its position.
The Alignment is only to be made by technical people who know well the functioning of the machine.
9.3 PERPENDICULAR ALIGNMENT OF THE BLADE WITH THE CART.
The blade needs to be totally perpendicular with the cart. If it is not, loosen the screws of the supports of the
rotation shaft that holds the cutting head and regulate it until reaching the perpendicular position. To check that, you
can use the set square, putting it on the base of the cart and recording the vertical side of the blade to make sure that
the blade and the set square are parallel.
When the parallelism has been achieved, tighten the cutting head supports.
12
ENGLISH
