6. ELECTRICAL EQUIPMENT.
The MAGNUM 700L and 1000L electrical installation has an IP55 protection degree and complies with EC
safety norms.
The electrical starters that are mounted in this machine perform the following functions:
• Electric box with a security gate.
• Sectioning.
• Sectioning housing.
• Emergency stop with housing.
• Protection against short circuits.
• Protection against overcharge.
• Control through buttons: 1 Start selector "ON" and one Stop selector "OFF".
• A double insulation protection of IP657 degree.
In case of a short cut or low tension that stops the machine and once the normal condition is back, the motor
will not start until you reset the emergency stop system. To do this, set the star-delta switch to position "0".
7. MOUNTING AND DISMOUNTING THE BLADE.
The table saws MAGNUM 700L and 1000L have been designed to use diamond segmented blades or blades with
continuous rim with 700mm and 1000mm diameter, respectively.
7.1 MOUNTING OR REPLACING A CUTTING BLADE.
To mount or replace a cutting blade, proceed as follows:
• Make
sure
the
supply
cable
machine is disconnected.
• Remove
the
safeguard
(P,
loosening
the
that fix it (A, Fig.4) with
the
hex
spanner
Fig4).
• Block the rotation of the
axis inserting a key (C,
Fig.4) in the slots of the
shaft (on the back side
of the blade).
• Loosen
the
nut
Fig.4) with spanner (E,
Fig.4).
Remove
exterior
flange
Fig.4).
• Place the blade on its
shaft ensuring it is well
centred
and
perfectly
located.
• Place the exterior flange
back and tighten the axis nut using the set of spanners used before.
• Check the coupling between the blade and the flanges before tightening the nut.
Make sure the rotation sense of the blade is correct, it should match with the arrow marked on the blade and on the
safeguard.
Place the lateral part of the safeguard in position and tighten it.
WARNING: Remove the tools used and make sure that all the elements of the machine have been placed
in their correct position. Never use the machine without the blade safeguard placed in the right
position.
• Now, you can plug the machine.
• To dismount the blade, proceed to the reverse.
power
of
the
blade
Fig.4)
screws
(H,
(D,
the
(F,
9
ENGLISH