Hilti DX 9-ENP Manual De Instrucciones página 45

1. Press the tool vertically down on to a solid surface, pull the triggers and listen to the resulting noise.
Result 1 / 2
A cartridge is triggered or a clicking noise is clearly audible.
▶ There is now no triggerable cartridge in the cartridge magazine of the tool.
▶ Proceed to the next step in the troubleshooting routine.
Result 2 / 2
No cartridge is triggered and no clicking noise is audible. There might be a triggerable cartridge in the
tool, but it did not trigger on account of a fault.
▶ ATTENTION! Make sure that the tool's nail discharge muzzle is not pointing toward anyone.
▶ Avoid hard impacts on the tool.
▶ Proceed to the next step in the troubleshooting routine.
2. Press the nose of the tool in a few millimeters and open the rotating sleeve → page 31.
▶ The catch is now accessible and you can open the tool.
3. Pull the catch out and hold it in this position. If the tool does not open up by itself try pulling it open,
without applying more than ordinary muscle power.
▶ ATTENTION! Make sure that the tool's nail discharge muzzle is not pointing toward anyone.
Result 1 / 2
The tool can be pulled open.
▶ Proceed to the next step in the troubleshooting routine.
Result 2 / 2
The tool cannot be pulled open.
▶ Cease work and lay the tool down at a safe place.
▶ Make sure that the tool cannot be accessed by other persons.
▶ Notify Hilti Service immediately.
4. Remove the cartridges from the tool. → page 33
5. Disassemble the base plate. → page 34
6. Check the piston and piston brake and replace these parts if necessary. → page 34
7. Clean the fastening tool. → page 35
8. Close the rotating sleeve. → page 31
8.3 Troubleshooting
If the trouble you are experiencing is not listed in this table or you are unable to remedy the problem by
yourself, please contact Hilti Service.
Trouble or fault
The cartridges are not trans-
ported.
The cartridge strip cannot be
removed.
The tool doesn't fire.
*2241307*
Possible cause
The cartridge strip is damaged.
The tool is damaged.
The tool is damaged.
Misfire
The cartridge strip is used up.
There are less than 15 fasteners in
the tool.
The tool is not adequately com-
pressed.
Fastener transport malfunction.
2241307
Action to be taken
▶ Change the cartridge strip. Do
not attempt to forcibly remove
cartridges or the cartridge strip.
▶ Contact Hilti Service.
▶ Contact Hilti Service.
▶ Remedy the malfunction.
→ page 36
▶ Remove the cartridge strip from
the tool.
▶ Insert a new cartridge strip.
▶ Load new fastener strips.
▶ Press the nose of the tool
against the working surface
again and pull the trigger.
▶ Check that the fastener strips
are free to move.
▶ Remove any damaged or
defective cartridge strips or
strips containing damaged or
defective fasteners.
English 37