Buffalo CH133 Manual De Instrucciones página 5

Operation
1. Cut the meat into small enough pieces to fit in to the hole in
the hopper tray.
2. Connect the appliance to the power supply.
3. Press the Start button to start mincing.
4. Feed the meat into the shaft using the food pusher.
Warning: Never push meat into the shaft using fingers.
5. After use, press the Stop button to turn off then disconnect
from power supply.
Note: If too much meat stuffed/jammed, press the Reverse button to run in the reverse
direction to clear the blockage. After 2 seconds, press the Start button to continue.
Overload protection
The appliance is featured with overload protection. In case of overload, the appliance will stop working
automatically.
1. Turn Off the appliance and allow to cool for several minutes.
2. Press the "RESET" button.
3. Press the Start button to continue.
Cleaning, Care & Maintenance
Warning: Always switch off and disconnect the appliance from the power supply before
cleaning. No parts are dishwasher safe!
• Do not use any abrasive cleaning agents on the appliance. Use warm soapy water.
• Do not immerse the motor housing in water. Clean the exterior with a damp cloth.
• Always dry thoroughly after cleaning.
For ease of cleaning, disassemble the appliance:
• Rotate the locking handle anti-clockwise to loosen the mincing
barrel.
• Remove the mincing barrel, plate, blade and feed screw as one unit.
Gently tip the barrel to remove the pieces one by one.
• Twist off the hopper tray.
• Remove meat from all components and wash in warm, soapy water.
• Dry thoroughly.
• Lubricate the parts with a little cooking oil before re-locating for best
performance.
Technical Specifications
Note: Due to our continuing program of research and development, the specifications herein may be
subject to change without notice.
Model Voltage
CH133
230V~ 50Hz
CH134
230V~ 50Hz
CH133-CH134_ML_A5_v2_20230329.indb 5 CH133-CH134_ML_A5_v2_20230329.indb 5
Power Current
550W 2.5A 130kg/hour
735W 3.5A 250kg/hour
Start button Reverse button
Dimensions
Output
h x w x d (mm)
520 x 245 x 400
520 x 270 x 430
EN
Stop button
Weight
20.2kg
24kg
5
2023/3/29 15:27 2023/3/29 15:27