Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Notes:
Some types of motors do not have
injector, it contains automatic choke.
Some engine types have an automatic
throttle system, which allows for
greater fuel economy.
Crankcase Oil
The motor leaves the factory without oil, before
starting fill the crankcase with oil as recommended in
the motor manual in regions with atypical
temperature or altitude.
Open the dipstick cap and fill the amount of oil into
the feeder tube, then check the level with the
dipstick.
EXI coconut crushers with EXI engine do not require
oil change, it just must be kept at the correct level as
indicated on the oil dipstick.
Always check the oil level before using the Crusher;
if the level is low, it must be topped up.
Low level
32
Changing the Oil - TR 200G
Correct level
Notes:
The engine does not respond upon
being accelerated without a load
(work force). The rotation only
increases when the machine is made
to work (under no circumstances
should the pressure of the original
spring of the accelerator be altered).
This motor has a power cut-off system
to facilitate the engine turn-off, before
starting, make sure it is not started,
this prevents turning the motor on.
If you choose to change the oil, remove the gasoline
from the gas tank, open the oil dipstick cap and tilt
the machine to pour the used oil into an appropriate
container, then follow the manufacturer's instructions
to dispose of the used oil. After removing the dirty
oil, follow the procedure described above to fill the
crankcase with new oil.
Some motors are factory fitted with a drain plug, in
which case, please see the specification in the motor
manual for oil change.
Warning!
Be careful: Gasoline is highly flammable.
Close the tank, thoroughly tightening
the cover to avoid leakage.
Never fill the tank with the motor on.
Switch the motor off before removing
the fuel cover.
Do not add gasoline while the motor is
hot.
www.trapp.com.br
Tabla de contenido
