Idiomas disponibles
Idiomas disponibles
Adjusting the transmission chain tension
NOTICE
Do not overtighten the chain as this
could cause premature wear of the
chain and the sprockets.
Proceed as outlined below.
1) Unscrew the nuts (A).
2) Remove the casing (B).
3) Loosen the nut (C).
4) Move the tensioner to tension the
chain correctly.
5) Tighten the nut (C).
6) Position the casing (B).
7) Tighten the nuts (A).
Adjusting the brake
Adjust the brake so that friction is ex-
erted that can ensure uniform dispenser
rotation.
An overtight brake would cause prema-
ture pad wear.
Proceed as outlined below.
1) Loosen the screws (A).
2) Move the brake support as shown in
the illustration.
3) Tighten the screws (A).
Adjusting the cup opening stage timing
Depending on the type of seedlings and on the rotation
speed, when the seedlings go down the dispenser they
may knock the side of the opening of the drop pipe and
fall in way which is not perpendicular.
The cam (A) adjusts the opening to the cup so that the
seedling is in the centre of the drop pipe (C).
The cam (B) adjusts the opening to the cup so that the
seedling is in the centre of the drop pipe (D).
NOTICE
Do not change the height of the cams set by the man-
ufacturer during testing.
English language
ADJUSTMENT INFORMATION
A
B
UN41-0902UA
UN41-0903UA
Proceed as outlined below.
1) Loosen the nuts (E) and adjust the cam (A).
- Move the cam (A) in direction (1) to make the cam
open earlier.
- Move the cam (A) in direction (2) to make the cam
open later.
- After adjusting, tighten the nuts (E).
2) Loosen the nuts (F) and adjust the cam (B).
- Move the cam (B) in direction (1) to make the cam
open earlier.
- Move the cam (B) in direction (2) to make the cam
open later.
- After adjusting, tighten the nuts (F).
18
5
C
A
A
Use and maintenance
