Idiomas disponibles
Idiomas disponibles
Adjustments & Maintenance
Doors
The cabinet doors have a three-way adjustment feature.
Height, level, and fi t-to-frame can all be adjusted using a
#2 Phillips Head screwdriver.
■
HEIGHT: If the door is too high or low, adjust the door
down or up with screw #2 as shown in Figure M. This
screw is located inside the hinge and requires the door
to be opened approximately 90° to access the screw.
■
LEVEL: If the door is out of level or too close to one
side, adjust the door to the left or right using screw #1 as
shown in Figure M.
■
FIT-TO-FRAME: If the door opens stiffl y, squeaks, or
rubs against the gasket, adjust the door outwards with
screw #3 as shown in Figure M.
Figure M
HINGE
1 2
DOOR
ADJUST DOOR PITCH
SIDE-TO-SIDE
USING SCREW #1
Door "Swing"
Check the swing of the door. The door hinges come with
a 110° black
plastic hinge stop so they will not swing into
a light kit. If no light kit is installed, the stop is not neces-
sary and the door can be allowed to swing 170°. If hinge
stops are required, snap the
the hinge into the holes located on the hinge.
"E" Option Doors
Activate the
door defogger from the switch on the outlet
shelf. Within 3 minutes the center portion of the door will
get warm.
The center area of
the mirror (approximately 2 square feet
[.1858 square meters]) will remain fog-free. If the defog-
ger does not function, check the wiring to the outlet shelf.
Do not attempt to repair the
viceable parts. Contact the factory or your dealer.
SS476 MP and MT Cabinets 01/27/06
MOUNT OR
UNMOUNT
DOOR,
OR ADJUST
FORWARD OR
BACKWARD
USING SCREW #3
3
ADJUST DOOR
UP/DOWN
USING SCREW #2
hinge clip over the elbow of
door. There are no fi eld-ser-
Final Assembly
1. Insert clear snap-in Shelf Clips into
the holes on the sides of the cabinet.
See Figure N.
2. Push one side of the shelf into the left or right clip (A).
3. Snap the shelf down into the opposite side (B). If the
shelf is too tight, repeat the process starting from the
opposite side.
4. Install the Shelf Hole Plugs into the unused holes
inside the cabinet by pressing them into the holes.
5. Place the grey Screw Head Caps over any exposed
screw heads.
Cleaning and Care
The cabinet door and interior are constructed of mirrored
glass and
anodized aluminum. Use only a damp cloth to
clean. Ammonia or vinegar-based cleaners can damage
mirrors. A 50/50 solution of water and isopropyl alcohol is
recommended for cleaning the mirrors. A mild detergent
may be used on the surfaces.
When cleaning, spray the cloth, not the cabinet, mirror,
or surround surfaces.
Do not use abrasive cleansers on any part of the cabinet.
NOTE:
Do not store items in the cabinet area directly
behind the hinge as damage may occur to
cabinet or items.
8
Figure N
A
B
