Idiomas disponibles
Idiomas disponibles
ENTERING YOUR SECURITY CODE
To enter your own security code you will need to
follow the steps listed below:
1. After installing the batteries, locate the reset
button on the back of the door.
2. With the safe door open,
the locked position - you can not program the
keypad if the key is in the unlocked position.
3. Press the reset button with a pen and then
release it. The light will flash green
with one beep
4. With the door open, enter your own personal
security code, which can be 3 - 8 digits long, and
confirm your new code by pressing the
key on the electronic touch pad. You will have
3 seconds to press the
will have to start over from step one. There will
be 2 beeps (if the sound is turned on) and the
green light will flash twice if your code has been
entered successfully. Before you close the door,
enter the new security code and press the ....
key to make sure the lock bolts retract.
If the code fails, go through steps 2 - 4 again.
If the code works successfully, then you should
lock the safe.
NOTE:
DO NOT SHUT THE DOOR UNTIL YOU
HAVE CONFIRMED THAT YOUR COMBINATION
HAS BEEN ENTERED CORRECTLY.
the key must be in
....
....
key otherwise you
LOCKING THE SAFE
NOTE ON LOCKING THE SAFE: Because the
locking mechanism is deactivated for
approximately 3 to 6 seconds after the
combination
is entered, wait a minimum of
6 seconds from the time the
entered to lock the safe.
When operating the lock with the key, you must
turn the key back to the locked position before
you are able to close and lock the safe door.
OPENING THE SAFE
When you open the safe in the future enter the
security code you have set followed by
the .... key.
If an incorrect security code is entered 3 times
the safe will beep 5 times (if the sound is turned
on) and the red light will flash 5 times resulting
in the safe being automatically locked out for
60 seconds before you can try your code again.
The safe will beep 1 time (if the sound is turned
on) and the green light will flash once when the
lockout period is over.
If an incorrect security code is entered
1 additional time the safe will beep 5 times
(if the sound is turned on) and the red light will
flash 5 times resulting in the safe being
automatically locked out for 5 minutes before
the code can be tried again.
1 time (if the sound is turned on) and the green
light will flash once when the lockout
period is over.
Write your new combination on this form or
store your combination on our secure website at
stackon.com under Customer Service. If you
write down your combination you must keep this
information in a secure place, away from
children, not inside the safe.
combination
is
The safe will beep
3
16
40716-1705
