Idiomas disponibles
Idiomas disponibles
GETTING STARTED
When you first receive your safe you will
need to open the door with the key in order
to install the batteries. Batteries are
included and are located inside the safe.
To open the door with the key, first remove
the lock cover from the front of the faceplate
using a thin bladed flathead screwdriver.
Insert the key and turn clockwise.
The door will open automatically when the
key is in the open position.
NOTE: You must turn the key back to the
locked position before you can record a
combination, close and lock the door.
NOTE: This key has also been provided in case
the batteries run low. If you lose your key, you
may purchase a replacement key by referencing
the serial number located under the removable
lock cover. See section at the end of this
instruction regarding replacement keys.
BATTERY INSTALLATION
NOTE: Do not mix old and new batteries. Do not
mix alkaline, standard or rechargeable batteries.
This safe uses 4 - AA batteries. Under normal
use, batteries will last about 1 year.
NOTE: If the batteries are low, the yellow light
will flash when you press the keypad.
Locate the batteries inside the safe. Open the
battery compartment on the back of the door
by pushing the tab in the direction of the
arrow and install the batteries. The light will
flash green with one beep if batteries are
installed correctly.
Battery
Compartment
Reset Button
INSIDE SAFE DETAIL
NOTE: The reset button located on the inside
of the door, is covered with a removable cap.
When you use the reset button while
recording your combination, remove the cap
to access the button. Use a pen tip to push
the reset button.
Replace the cap securely over the reset
button after recording your Combination.
Failure to do so will compromise the safety
and security of the safe.
2
16
40716-1705
