Idiomas disponibles
Idiomas disponibles
EN
holes over 8.0 mm in diameter you
should first drill with a bit with
a smaller diameter.
SWITCHING ON AND OFF
!!!Make sure that the power
supply voltage matches
the voltage rating indicated
on the device's type plate.!!!
- Connect the machine to the power
supply.
Caution! Fold the protective
device (7) down before
you switch on the machine.
SWITCHING ON: Press the on
switch (2).
SWITCHING OFF: Press the off
switch (1).
EMERGENCY STOP: Press the
emergency stop button (5).
!!!After pressing the emergency
stop button, the emergency stop
button (5) must be activated
again by turning it.
Press the on switch (2)
to restart the device.!!!
CLAMPING
THE WORKPIECES
Only work with workpieces that can
be securely clamped.
The workpiece must not yield too
much. Otherwise it is nor possible
to apply adequate tension.
The workpiece must not be too
small or too large either.
REMOVING BLOCKAGES
- You should always select a suitable
feed rate which allows trouble-free
chip breaking.
- If the bit is jammed in the
workpiece, turn off the power
and unplug the power cord.
Turn the bit on the drill chuck anti-
clockwise with a little jerk to break
the chip and release the bit again.
- If a fragment is produced during
the processing of the workpiece,
32
turn off the power and unplug
the power cord. Use a pair of pliers
and remove the fragment to prevent
it flying off in an uncontrolled way.
CLEANING AND SERVICING
Pull the mains plug before any
adjustments, maintenance or repair.
!!!Have any work on the device
that is not described in this
instruction guide performed by
a professional. Only use original
parts. Allow the device to cool
off before any maintenance or
cleaning is undertaken.
There is a risk of burning!!!!
Always check the device before
using it for obvious defects such
as loose, worn or damaged parts,
correct the positioning of screws or
other parts. Exchange the damaged
parts.
CLEANING
!!!do not use any cleaning
agents or solvents. chemical
substances can etch the plastic
parts of the device. never
clean the device under running
water.!!!
• Thoroughly clean the device after
every use.
• Clean the ventilation openings
and the surface of the device with
a soft brush or cloth.
• Remove chips, dust and dirt with
a vacuum cleaner if necessary.
• Lubricate moving parts regularly.
• Do not allow lubricants to come
into contact with switches, V-belts,
pulleys and drill lifting arms.
STORAGE
• Store the appliance in a dry place
well out of reach of children.
• The device can be relocated over
a short distance with two people.
Relocating the device over a longer
distance generally has to take place
with a transport aid.
WASTE DISPOSAL
AND ENVIRONMENTAL
PROTECTION
Be environmentally friendly. Return
the tool, accessories and packaging
to a recycling centre when you have
finished with them.
Electrical machines do not belong
with domestic waste.
• Hand over the device at an
utilization location. The plastic
and metal parts employed can
be separated out and thus recycled
use can be implemented.
Ask our Service-Center for details.
• Defective units returned to us will
be disposed of for free.
