Idiomas disponibles
Idiomas disponibles
Main light
The settings in the main light define the behaviour for
switching on the lighting when someone is present.
When constant light control is deactivated, the required
light output is set via the dimming level.
When constant light control is activated, the lighting is con-
trolled to the set brightness value.
The minimum light output that the controller must not fall
below is then set via the dimming level. If 0% is selected,
the controller can switch off the lighting completely if there
is enough daylight. If the brightness falls below the target
value again, the controller automatically switches the
lighting back on.
The desired lighting duration of the main light can be set
via the stay-ON time.
Any motion detected before this time has elapsed restarts
the stay-ON time.
The fade time can be used to set the dimming curve when
switching on and off.
Basic light
The settings in the basic light define the behaviour after
the main light has been left after the stay-ON time has
elapsed, if there is no one present.
It is switched back to the main light state if motion is
detected during the basic light state.
The basic light can be deactivated or configured with the
brightness-based or time-based functions.
With the basic light deactivated, the lighting is switched off
immediately after the stay-ON time of the main light has
elapsed. The basic light state is not executed.
– 74 –
Index
