STEINEL IR Micro Office DALI-2 Manual De Instrucciones página 55

The following applies to the wiring of the sensor:
According to VDE 0100 520 Section 6, a multi-core cable
containing both the mains voltage lines and the control
lines (e.g. NYM 5 × 1.5) can be used for wiring between
the DALI electronic ballast (control gear) and the DALI
application controller.
The maximum cable length between the DALI application
controller and the DALI electronic ballast (control gear)
should not exceed 300 m (at 1.5 mm²). After installation
and switching on, the LED of the sensor lights up for
10 seconds.
– 55 –
Index