Idiomas disponibles
Idiomas disponibles
11 Suction opening
12 Hose connection
13 Collection container
14 Attachment device for the nozzle attachments
15 Rollers
16 Chassis frame
17 Lever for extending and retracting the brush
18 Floor nozzle
Accessories
19 Crevice nozzle
20 Brush nozzle
Without Illustration
Permanent filter (for dry vacuuming)
Sealing ring (for wet vacuuming)
Protective foam filter
Warnings for the Use of the Appliance
WARNING:
• Only use the appliance in damp rooms if a residual
current circuit breaker has been connected upstream
in the circuit for your protection. If in doubt, consult an
authorised electrician.
• If the appliance, which is filled with water, should acci-
dentally tip over, always unplug it from the wall socket
before standing it up again.
• Never use it to suck up explosive liquids (such as
heating oil, petrol, paint thinner, acetone) and dusts
(such as magnesium and aluminium dusts), flammable
gases as well as undiluted solvents and acids, there
is a risk of explosion! Explosive vapours or mixtures
could be created by swirling the suction air. These
substances could attack the parts and materials used.
CAUTION:
• Pay attention to the limited range due to the cable
length!
• Switch off the appliance immediately in the following
situations:
- In case of foam formation.
- In case of liquid leakage.
- When the container is full.
- If the appliance is tipped over.
• Do not vacuum foam-forming cleaning agents with
the appliance!
• When vacuuming liquids, always remove the perma-
nent filter. Insert the sealing ring instead.
• Check that the protective filter is correctly seated.
• Before you vacuum dry again the next time, all compo-
nents must be dry again.
10
BS1313_IM_new - SH separat
CAUTION:
• When vacuuming smooth floors dry with the floor
nozzle, be sure to use it with the brushes extended to
avoid damaging the floor.
Putting Into Operation
If not already done, remove the supplied parts from the
collection container.
Mounting the Carrying Handle
Mount the carrying handle with the two enclosed screws.
Hand-tighten the screws with a suitable screwdriver.
Mounting the Rollers
Before you use the appliance, fasten the rollers to the chas-
sis frame of the collection container.
1. Detach the motor housing from the collection container
by pressing the latches inwards.
2. Remove the motor housing from the collection container.
3. Place the collection container upside down.
4. Insert the rollers with the pins into the provided holes as
far as they will go.
5. Turn the collection container back round so that it stands
on the rollers.
Inserting the Filter
1. Insert the Permanent Filter
(only when Vacuuming Dry)
The appliance has a permanent
filter. It is easy to insert and clean.
• Put the rubber rim of the perma-
nent filter over the edge of the
collection container. It serves
as an airtight seal for the motor
housing.
2. Protective Foam Filter
A protective foam filter is located underneath the motor. It is
needed for both wet and dry vacuuming.
• If not already fitted, place the protective filter on the
suction strainer.
• Regularly check that the filter is correctly fitted and in
good condition.
Putting on the Motor Housing
• If you do not use the permanent filter, always attach the
supplied sealing ring. Fit it over the edge of the collection
unit.
- Ensure that this rubber seal always sits correctly on
the edge of the container. If this is not the case the
suction power is lost.
• Align the motor housing so that the on / off switch sits
above the intake opening.
13.02.23
