Idiomas disponibles
Idiomas disponibles
– You can set the beeper to sound and the backlight to flash as a continuity
NOTE
– The continuity function detects intermittent shorts lasting as short as 1 ms.
– You can enable or disable the visual alert via the Setup menu. See
Changing the continuity visual alert
You can set the backlight to flash along with the beeper sound as a continuity
indication whether the circuit-under-test is less than the threshold resistance.
Follow the steps below to enable or disable the continuity visual alert.
1 Press and hold
2 Press
3 Press
4 Press
5 Cycle the clamp meter's power to exit the Setup menu.
Keysight U1190A Series User's Guide
indication whether the circuit-under-test is less than (short) the threshold
resistance.
A brief short causes the clamp meter to emit a short beep and flash.
the continuity visual alert"
while powering on the clamp meter to enter the Setup
menu.
again. The continuity visual alert (
shown.
to make changes to the continuity visual alert.
Press
or
to enable or to disable the continuity visual alert (the
backlight turns on or off).
to save the changes, or press
proceed to the next Setup item.
on page 51 for more information.
) is the fourth Setup item
to discard the changes and
Making Measurements
"Changing
2
51
