Idiomas disponibles
Idiomas disponibles
3
Clamp Meter Features
Capturing Maximum and Minimum Values (Max.Min)
The Max.Min operation stores the maximum, minimum, and average input values
during a series of measurements.
When the input goes below the recorded minimum value or above the recorded
maximum value, the clamp meter beeps and records the new value. The clamp
meter also calculates an average of all readings taken since the Max.Min mode
was activated.
From the clamp meter's display, you can view the following statistical data for any
set of readings:
– Max: highest reading since the Max.Min function was enabled
– Min: lowest reading since the Max.Min function was enabled
– Avg: average or mean of all readings since the Max.Min function was enabled
– MaxMinAvg: present reading (actual input signal value)
1 Press and hold
2 Press
3 Press
Figure 3-5
If an overload is recorded, the averaging function will be stopped.
NOTE
place of the average value.
72
again to cycle through the Max, Min, Avg, or present (MaxMinAvg)
input values.
for more than 1 second to disable the Max.Min function.
Max.Min display
for more than 1 second to enable the Max.Min operation.
Keysight U1190A Series User's Guide
is shown in
