Idiomas disponibles
Idiomas disponibles
Preparing Your Clamp Meter
Checking the shipment
When you receive your clamp meter, check the shipment according to the
following procedure.
1 Inspect the shipping container for damage. Signs of damage may include a
2 Carefully remove the contents from the shipping container, and verify that the
3 For any question or problems, refer to the Keysight contact numbers on the
Installing the batteries
Your clamp meter is powered by two 1.5 V AAA alkaline batteries (included with
the shipment). When you receive your clamp meter, the AAA alkaline batteries are
not installed.
Use the following procedure to install the batteries.
Before you proceed with the batteries installation, remove all cable
CAUTION
connections to the terminals and ensure that the rotary switch is at the OFF
position. Use only the battery type specified in the
"Characteristics and
Keysight U1190A Series User's Guide
dented or torn shipping container or cushioning material that indicates signs
of unusual stress or compacting. Save the packaging material in case the
clamp meter needs to be returned.
standard accessories and your ordered options are included in the shipment
according to the standard shipped items as below:
– Test leads with 4 mm tips
– 1.5 V AAA Alkaline battery
– K-type thermocouple (only for U1194A)
– Soft carrying case
– Certificate of calibration
back of this manual.
Specifications".
Introduction
Chapter 4,
1
19
