Ice Maker - Gaggenau RY 492 Instrucciones De Uso

Ice maker

Fault
The ice maker doesn't work.
The ice maker does not make
enough ice or the ice is
deformed.
The ice maker does not make any
ice.
Ice forms in the inflow hose
to the ice maker.
Water runs from the appliance.
26
Possible cause
Ice maker is not connected to the mains
supply.
Ice maker does not contain any fresh
water.
The freezer compartment temperature is
too warm.
The appliance or ice maker has only just
been switched on.
A lot of ice has been taken.
Low water pressure.
The water filter is bunged up or used.
Temperature in the freezer compartment
is too warm.
Ice cubes have accumulated on the rear
panel of the ice cube container.
The ice maker is switched off.
The appliance is not supplied with water. Contact the installer or the water supply com-
Water supply has kinks.
Low water pressure.
Temperature in the freezer space is too
warm.
Ice cube container is not properly
inserted.
Incorrect shut-off tap installed.
Low water pressure.
Shut off tap incorrectly opened.
The water connection hose is not prop-
erly sealed.
Incorrect shut-off tap installed.
Remedial action
Call customer service.
Ensure that the water is properly connected.
Check freezer compartment temperature and,
if required, set slightly colder.
Approx. 24 hours is needed until ice production
starts.
Approx. 24 hours is needed until the ice cube
container is filled again.
Connect the appliance to the stipulated water
pressure only (see chapter Connecting appli-
ance, section Water connection).
Change the water filter.
Set temperature slightly colder in the freezer
compartment.
Distribute ice cubes in the ice cube container. If
ice cubes are stuck to each other, loosen with
a blunt implement.
Switch the ice maker on at the control panel.
pany.
Turn off the water supply at the shut-off tap.
Smoothen out the kinks, exchange where nec-
essary.
Connect the appliance to the stipulated water
pressure only (see chapter Connecting appli-
ance, section Water connection).
Set temperature slightly colder in the freezer
compartment.
Check the position, re-insert where necessary.
Incorrect taps can cause low water pressure
and damage to the appliance.
Connect the appliance to the stipulated water
pressure only (see chapter Connecting appli-
ance, section Water connection).
Open shut off tap fully.
Replace the hose with a manufacturer's origi-
nal part.
Incorrect taps can cause low water pressure
and damage to the appliance.