Idiomas disponibles
Idiomas disponibles
Troubleshooting
Setting wheel steady light:
The electronic signal display [4] lights up
and the load speed decreases.
The machine load is too high!
▸
Run the machine in idling until the electronic signal
display goes out.
Setting wheel flashes:
The electronic signal display [4] flashes and
the machine does not start. The restart
protection device has tripped. If the mains
plug is inserted with the machine switched
on, or if the power supply is restored after an
interruption, the machine does not start.
▸
Switch the machine off and on again.
Accessories and spare parts
If in spite of careful manufacturing and test proce-
dures, the device becomes faulty, a repair by
Würth masterService should be arranged. With
any enquiries or spare parts orders, always quote
the item number as given on the device type plate.
The latest spare parts list for the device is available
online at http://www.wuerth.com/partsmanager.
Alternatively, contact your local Würth agency for a
hardcopy.
Repairs to power tools may only be
performed by an electrical specialist!
A defective power cord may only be
replaced with a special, original power
cord from Würth which are available
from Würth masterService.
Use only accessories which satisfy the requirements
and technical data specified in this instruction
manual.
Disposal
Do not dispose of this device with
household waste. Dispose of the
device via an approved waste disposal
company or via your local authority
waste disposal facility. Observe the
currently valid regulations. In case of doubt, contact
your waste disposal facility. Dispose of all packag-
ing in an environmentally compatible manner.
28
Warranty
We provide a warranty for this Würth device from
the date of purchase and in accordance with the
legal/country-specific regulations (proof of purchase
through invoice or delivery note). Damage that has
occurred will be corrected either by replacement or
by repair. Damage caused by improper handling is
not covered by the warranty. Claims under warranty
can only be accepted if the device is returned fully
assembled to a Würth agency, your Würth sales
representative or an authorised Würth customer
service workshop. Subject to technical changes with-
out prior notice. We accept no liability for printing
errors.
EC Declaration of Conformity
We declare under our sole responsibility that this
product conforms to the following standards and
directives:
Standards
• EN 60745-1:2009 + A11:2010
• EN 60745-2-3:2011 + A2:2013 +
A11:2014 + A12:2014
in accordance with the regulations stipulated in the
directives:
EC Directive
• 2006/42/EC
• 2014/30/EU
• 2011/65/EU
Technical documentation at:
Adolf Würth GmbH & Co. KG, Abt. PPT
Reinhold-Würth-Straße 12 – 17,
74653 Künzelsau, GERMANY
F. Wolpert
Head of Product Man-
agement,
Authorised Signatory
Künzelsau: 30.08.2018
Dr.-Ing. S. Beichter
Head of Quality,
Authorised Signatory
