Troubleshooting; Warranty - Tineco iFLOOR3 BREEZE Serie Manual De Uso

Brush Roller Cover
1.Grab the front handle while pressing the
button and pull upward to remove.
Fig.D-7
2.Rinse with water.
Fig.D-8
3.When replacing, always latch the brush cover
into place to avoid leakage.
Fig.D-9
Brush Roller
1.Remove the brush roller by grabbing the brush
roller tab and pulling upward.
Fig.D-10
2.Remove the hair and debris wrapped around the
roller and rinse with water (brush roller tab can
be removed). Replace the brush roller back onto
the storage tray, and allow it to dry completely
before reinstalling.
Fig.D-11
3.Remove hair and debris from the brush roller
chamber and the opening with a tissue or a
damp cloth.
Fig.D-12
4.Replace the brush roller by inserting the brush
roller end into the right side of the holder,
then lock the pull tab into place by pressing
downward.
Fig.D-13

TROUBLESHOOTING

Problem
The appliance
does not turn on
Weak suction
Solution
Charge the appliance
Empty the dirty water
and then reinstall the
DWT
Clean the sponge and
filter
Remove blockages
Too much wear of brush
roller, please replace it
Problem
Abnormal motor
sounds
Appliance won't
charge
Air outlet cover is
leaking water
Note:
If the above troubleshooting guide fails to
provide a solution, please visit our website
www.tineco.com for further support.

WARRANTY

2-YEAR LIMITED WARRANTY
• Only applies to purchases made from
authorized retailers of Tineco.
• Is subject to the adherence of the requirements
outlined in this instruction manual, and is
subject to further conditions outlined below.
• This warranty is governed by and construed
under the laws of the country in which the
purchase took place. We provide 2-year
warranty or a warranty period as stipulated by
applicable local law, whichever is longer.
WHAT IS COVERED?
• Your Tineco appliance has a 2-year warranty
against original defects in material and
workmanship, when used for private household
purposes in accordance with the Tineco
Instruction Manual. Motorized accessories and
11
Solution
Remove blockages
Empty the dirty water
and then reinstall the
DWT
Use the original adaptor
Reinsert the adaptor
correctly
Install the floater and the
sponge correctly
Empty the dirty water
and then reinstall the
DWT
Allow the sponge to dry
completely
Remove blockages