Preservation Of The Appliance; Technical Data; Trouble Shooting; Before Calling For Service - Olimpia splendid AQUARIA S1 20 P Instrucciones Para El Uso Y El Mantenimiento

Do not use detergent, scouring pads, chemically treated dust cloths, gasoline, benzene,
thinner or other solvents, as these can scratch and damage the tank and cause water
leakage.

5 - PRESERVATION OF THE APPLIANCE

If you do not intend to use the appliance for a particularly long period of time or if operations which could
produce a lot of dust must be performed, it is advised to store the appliance as follows:
• Switch the appliance off and disconnect the plug from the power socket.
• Empty any water remaining in the tank.
• Wrap the supply cord and position it in the water tank (after making sure that the tank is completely dry).
• Clean the filter.
• Store in a fresh and dry place away from humidity.

6 - TECHNICAL DATA

Consult the data plate applied to the product (Fig. 2) for the technical data listed below:
Supply voltage

7 - TROUBLE SHOOTING

BEFORE CALLING FOR SERVICE

Before contacting professional service, consult this list.
This list includes common occurrences that are not the result of a defect in workmanship or materials.
Low temperature operation with Auto Defrost function
The appliance is equipped with an automatic defrost function (indicated by the specific led "L4" switching
on) which, thanks to opportunely timed intervals and by checking room temperature, adjust the machine
operation.
PROBLEM
The unit doesn't operate.
The dehumidifying function
doesn't work or the unit turn
on / off frequently.
Operation is noisy.
The display shows E1.
The keys of the control
panel do not work.
EN - 16
Absorbed power
POSSIBLE CAUSES
The supply cord is disconnected.
The tank full warning led is turned on (tank full or
not correctly positioned).
Room temperature exceeding the maximum work
conditions of the appliance.
Compressor protection is active (the unit cannot
work).
Filter is clogged.
Filter damaged.
Door or window open.
The air inlet/outlet grilles are clogged.
The room is too large or there's too much
humidity.
The unit is tilted or unsteady.
Filter is clogged.
Filter damaged.
Temperature sensor faulty.
Mode "Child Lock" active.
Insulation class
ADVISED SOLUTIONS
Insert the plug in the power socket and make
sure there's electrical voltage.
Drain water tank and reset your setting, or
replace the water tank to right place.
Self-Protection designed to protect the unit.
Can not work under such temperature.
Clean the filter.
Replace the filter.
Close the door and/or the window.
Remove the obstruction or clean the air inlet/
outlet grilles.
If possible, remove or reduce the level of
humidity.
Place the appliance on an even, solid surface
(less vibration).
Clean the filter.
Replace the filter.
Call the service center.
Deactivate the mode "Child Lock".
Appliance weight