Removing The Seat Cover - Cosatto cabi Manual De Instrucciones

8

removing the seat cover

1. Loosen the TMS system.
2. Remove the straps from the distribution plate. Then remove the buckle located at the front of
the seat.
NOTE: Never remove the polystyrene inner protection from the car seat.
9 attaching the car seat to the chassis
Before the car seat can be attached you will need to connect the two adaptors. Connect the
adaptors as shown inserting the prongs of each adaptor into the inner slots of the plastic
housing on the chassis
Lower the car seat into place ensuring the adaptors either side of the chasssis fully connect with
the car seat.
To remove, press in the two release buttons either side of the car seat.
NOTE: Do not disconnect the adaptors along with the seat - remove the adaptors separately once
the car seat has been removed.
1.
This is a 'Universal' child restraint. It is approved to ECE Regulations 44.03 for general use in
vehicles and will fit most, but not all, car seats.
2.
A correct fit is likely if the vehicle manufacturer has declared in the vehicle handbook that the
vehicle is capable of accepting a 'Universal' child restraint for this age group.
3.
This child restraint has been classified as 'Universal' under more stringent conditions than those
applied to earlier designs which do not carry this notice.
4.
If in doubt, consult either the child restraint manufacturer or the retailer.
Only suitable if the vehicle is fitted with
3 point static or 3 point retractor safety
belts, approved to UN/ECE Regulations
All manuals and user guides at all-guides.com
notice
EXTREME HAZARD
Do not use in passenger
seats equipped with airbags
(SRS)
No.16 or other equivalent standards