Adjusting The Harness - Cosatto Moova 2 Manual De Montaje

4 - seating your child into the car seat harness
Loosen the harness by pushing the adjuster button (a) in as you pull the harness straps
(b) forward as much as possible.
IMPORTANT: Pull the harness UNDER the chest pads. DO NOT
pull on the chest pads.
Unfasten the harness buckle by pressing the red button (c) and releasing the clips (d) and
open out the belts (e).
Place your child in the child car seat.
Fit the harness around your child and fasten the harness buckle by joining the clips (f)
and pushing them both into the buckle (g).
The harness must fit level with the top of your child's shoulders. It must not fit above or
below the shoulder line. (Refer to step 6).
5 - seating your child into the car seat harness
Check that the harness is not twisted. Pull the harness up (a) to tighten the lap
sections which is designed to fit low down on your child's body.
Pull the adjuster strap forward (b) making sure the harness is a comfortable but FIRM fit
around your child.
Finally, pull both chest pads down (c) from your child's shoulders onto their chest.
NOTE: The chest pads are an important safety feature. Never use the
child car seat without them.

6 - adjusting the harness - 1

Recline the car seat to its most reclined position (position 3) to gain access to harness
connector. (See step 3).
Remove the upper seat liner (b).
Loosen the harness by pushing the adjuster button (c) in as you pull the harness straps
forward as much as possible (d).
Important: Pull the harness UNDER the chest pads. DO NOT pull
on the chest pads.
Pull out the harness connector (e) from between the child car seat back and seat base.
Slide the harness straps off the harness connector (f).
Pull the harness straps through the child seat back and out of the chest pads (g).
Unclip the chest pad strap from the connector (h) behind the seat back, then pull the
chest pads out of the seat back (i).
7 - adjusting the harness - 2
Refitting the harness: Push the chest pad straps through the seat back (a) and fasten the
connector behind the seat back (b).
Push the harness straps through the chest pads and seat back (c) and refit the ends to the
harness connector (d) making sure the strap ends are correctly fitted and not twisted (e).
Fit the upper seat liner (f).
Pull the harness strap at (g) to tension the harness.