To Assemble The Guide Bar And Saw Chain (With Bar Knob); Assembly - Husqvarna 225i Manual Del Usuario

• Only use approved guide bar/saw chain
combinations and filing equipment. Refer to
Technical data on page 36 for instructions.
• Use protective gloves when you use or do
maintenance on the saw chain. A saw chain that
does not move can also cause injuries.
• Keep the cutting teeth correctly sharpened. Obey the
instructions and use the recommended file gauge. A
saw chain that is damaged or incorrectly sharpened
increases the risk of accidents.
• Keep the correct depth gauge setting. Obey the
instructions and use the recommended depth gauge
setting. Too large depth gauge setting increases the
risk of kickback.
To assemble the guide bar and saw
chain (with bar knob)
WARNING:
before you assemble or do maintenance on
the product.
1. Disengage the chain brake.
1860 - 001 - 23.09.2022

Assembly

Always remove the battery
• Make sure that the saw chain has the correct
tension. If the saw chain is not tight against the guide
bar, the saw chain can derail. An incorrect saw chain
tension increases wear on the guide bar, saw chain
and chain drive sprocket. Refer to
page 36 .
• Do maintenance on the cutting equipment regularly
and keep it correctly lubricated. If the saw chain is
not correctly lubricated, the risk of wear on the guide
bar, saw chain and chain drive sprocket increases.
2. Loosen the bar knob and remove the drive sprocket
cover.
3. Put the guide bar on top of the bar bolt. Steer the
guide bar to its most rear position. Lift the saw chain
above the drive sprocket and engage it in the groove
on the guide bar. Start on the top edge of the guide
bar.
Accessories on
13