Assembly; Operation - Husqvarna Aspire T28-P4A Manual De Usuario

• Special training is necessary for all servicing and
repair work, especially for the safety devices on the
product. If not all checks in this operator's manual
are approved after you have done maintenance, turn
Introduction
WARNING:
safety chapter before you assemble the
product.
To attach the trimmer guard
1. Put the trimmer guard against the motor housing.
(Fig. 32)
2. Install the 2 bolts through the motor housing and the
trimmer guard. (Fig. 33)
3. Tighten the bolts.
To assemble the trimmer head
1. Turn the output shaft until the hole in the drive disc
aligns with the hole in the gear housing.
2. Install the combination tool in the hole to lock the
shaft.
3. Turn the trimmer head clockwise. (Fig. 34)
To install the plant guard
1. Install the plant guard into the holes on the motor
housing. (Fig. 35)
Introduction
WARNING:
safety chapter before you use the product.
Before you operate the product
• Examine the work area to make sure that you know
the type of terrain. Examine the slope of the ground
and if there are obstacles such as stones, branches
and ditches. • Do a general inspection of the product.
• Do the safety inspections, maintenance and
servicing that are given in this manual.
• Examine the motor for dirt or cracks. Use a brush to
clean the motor from grass and leaves. Use gloves
when it is necessary.
• Examine the trimmer head and cutting attachment
guard for damages or cracks. Replace the trimmer
head and cutting attachment guard if they are hit or if
they have cracks.
1885 - 004 - 22.09.2022

Assembly

Read and understand the

Operation

Read and understand the
to your servicing dealer. We guarantee that there are
professional repairs and servicing available for your
product.
• Only use original spare parts.
2. Make sure that the plant guard can move forward
and rearward freely. (Fig. 36)
To install the hook on the wall
• Install the hook indoors.
• Keep the hook out of sunlight and in ambient
temperature of -10°C to 70°C.
• Install the hook on a drywall, wood or concrete wall.
CAUTION:
can hold loads of minimum 30 kg.
• Install the hook on the wall with the 3 screws (A).
Use wall plugs (B) if it is necessary. (Fig. 37)
CAUTION:
screws are applicable for your wall type.
• Speak to your Husqvarna service agent for
information about available storage accessories for
your product.
• Make sure that all nuts and screws are tight.
• Make sure that all covers, guards, handles and the
cutting equipment are correctly attached and not
damaged before you start the product.
Battery
WARNING:
you must read and understand the safety
chapter. You must also read and understand
the operator's manual for the battery and the
battery charger.
Keep the battery and the battery charger in correct
ambient temperatures.
Ambient temperature
Operation of the bat- -20°C — 50°C
tery in the product
Charging of the bat- 0°C — 35°C
tery
Make sure that the wall
Make sure that the
Before you use the battery,
355