Warranty Disclaimer - Hama Nano Instrucciones De Uso

9. Switching illumination on/off
• Press the Power and Mute buttons simultaneously.
• If the LED ashes green once, the illumination of the
remote control is switched on.
• If the LED ashes red once, the illumination is switched off.
• When the illumination is switched on, it goes out each
time the button is pressed and lights up again for approx.
3 seconds as soon as the button is released.
10. Maintenance
• Never use old and new batteries in the universal remote
control at the same time, as old batteries tend to leak and
can lead to a loss of performance.
• Never clean the universal remote control with scouring
agents or harsh cleaning agents.
• Keep the universal remote control free of dust by cleaning
it with a dry soft cloth.
11. Troubleshooting
Q. My universal remote control does not work!
A. Check the AV device. If the main switch on the device
is off, the universal remote control cannot operate the
device.
A. Check that the batteries are inserted correctly and that the
polarity has been observed.
A. Check that you have pressed the appropriate device button
for the device.
A. Replace the batteries if the battery level is low.
Q. If there are multiple device codes listed for the brand of my
AV device, how do I select the correct device code?
A. To determine the correct device code for the AV device,
test the codes one after the other until most of the buttons
work properly.
Q. My AV device only responds to some button commands.
A. Try other codes until most of the buttons work properly.
Q. The brand of my AV device is not mentioned in the code
list.
A. In this case, use the code search for all brands (Section
5.1)
Q. I have tried all the available codes for the brand of my AV
device from the code list, but none of the codes mentioned
work.
A. In this case, use the code search for all brands (Section
5.1)

12. Warranty disclaimer

Hama GmbH & Co KG assumes no liability and provides no
warranty for damage resulting from improper installation/
mounting, improper use of the product or from failure to
observe the operating instructions and/or safety notes.
7