Grounding And Electric Requirements; Set Up Installation - Binks 0811-7500-4 Manual De Servicio

EN
Route hoses and cables away from traffic areas,
sharp edges, moving parts and hot surfaces.
Do not kink or over bend hoses or use hoses to
pull equpment.
Use genuine BINKS hoses. If provided, do not
remove the spring guards from hoses, these are
on the hoses to prevent rupture from kinking at
the connectors.
Keep children and animals away from work area.
Comply with all applicable safety regulations.
Do not operate equipment when fatigued or
under the influence of drugs or alcohol.
TOXIC FLUID HAZARD
Know the specific hazards of the fluid you are
using. This information is on the MSDS for the
material that is being used. Read all fluid
manufacturer's warnings.
Store hazardous fluids in approved containers
only. Dispose of all hazardous fluids in
accordance with all state, local and national
guidelines.
Wear the appropriate protective clothing, gloves,
eyewear and respirator.
GROUNDING AND ELECTRIC
REQUIREMENTS
The sprayer and gun must be grounded.
Grounding reduces the risk of static and electric
shock by providing an escape wire for the
electrical current due to static build up or in the
event of a short circuit. Follow the grounding
instructions included in the equipment manual
provided with all your spray equipment.
Additional grounding instructions for your BINKS
Airless 75M Spray Gun are provided:
Ground your BINKS Airless 75M Spray Gun
through connection to a properly grounded fluid
hose and pump.
BINKS AIRLESS 75M SPRAY GUN
8 / 14

SET UP INSTALLATION

WARNING
!
Never attempt to assemble, change, or
clean the gun, tip, or tip guard without first
relieving pressure from the spray system.
Follow the "PRESSURE RELIEF PROCEDURE"
in the sprayer's equipment manual.
WARNING
!
Always use tip safety guard for added
protection against injection. Beware that
the guard alone will not prevent injection.
NEVER cut off tip guard! Always engage
gun trigger lock when the gun is not in use.
Before servicing equipment, consult all
equipment manuals and follow all warnings.
WARNING
!
Do not allow fluid to exceed the fluid
manufactures recommended maximum
temperature. Gun must include heat guard
(54-7527) to be used with heated materials.
NOTE
BINKS Airless Spray Gun Safety Tip Guards
for the 7500 PSI (517 BAR) gun are gray in
color.
77-3084-R2.2 (7/2016)