Hub Lock; Q.sideguard Mount; Anti-Tip Tubes - Sunrise Medical Zippie ZONE Manual De Instrucciones

E N G L I S H
39 40
Q.HUB LOCK
39
To operate Hub Lock
1. To lock rear wheels, press button A. Lever B will flip outward.
2. To unlock wheels, press lever B back down until button A pops back out. Each lever
operates one side of the chair. To fully lock chair, both buttons must be pushed.
NOTE– Do not engage hub lock when chair is in motion.
40
To adjust the cables
1. Loosen jam nut (C) using a 10mm wrench.
2. Turn adjustment screw (D) in or out as necessary. Turning screw toward the housing
will loosen the cable. Turning screw away from the housing will tighten the cable.
3. Re-tighten jam nut (C) against lever mount.
4. Repeat steps 1-3 for opposite side of chair as necessary.
R. SIDEGUARD MOUNT
41
To Operate
1. To lock, lift handle (E) and pull lever towards backrest until it engages.
2. To unlock, lift handle (E) and slide forward to front of sideguard until it drops into
position.
40
To adjust the cables
1. Loosen jam nut (C) using a 10mm wrench.
2. Turn adjustment screw (D) in our out as necessary. Turning screw upward will loosen
cable, turning downward will tighten cable.
3. Re-tighten jam nut (C) against lever mount.
4. Repeat steps 1-3 for opposite side of chair as necessary.
S. ANTI-TIP TUBES
Sunrise Medical recommends anti-tip tubes for all wheelchairs. Use torque setting of 62 in-
lbs. (7 Nm) when installing anti-tip tubes.
1. Inserting Anti-tip Tubes Into Receiver
a. Press the rear anti-tip release button (F) on the anti-tip tube so that both release pins are
drawn inside.
b. Insert the anti-tip tube (G) into the anti-tip receiver (H).
c. Turn the anti-tip tube down until release pin is through the receiver mounting hole.
d. Insert second anti-tip tube the same way.
2. Adjusting Anti-Tip Tube Wheel
The anti-tip wheels may have to be raised or lowered to achieve proper clearance of
1 1/2" to 2".
Press the anti-tip wheel release button (I) so that both release pins are drawn inside. Raise or
lower to one of the three predrilled holes (J). Release button. Adjust the second anti-tip tube
wheel the same way. Both wheels should be the same height.
3. Turning Anti-Tip Tubes Up
Turn anti-tip tubes up when being pushed by attendant, overcoming obstacles or climbing
curbs. Press the rear anti-tip tube release button
up. Release the lever and repeat with second anti-tip tube. Remember to return anti-tip
tubes to down position after completing maneuver.
All manuals and user guides at all-guides.com
40 41
42 43
(Optional)
42
42
43
42
-F. Hold lever in and turn anti-tip tube
Locked
Unlocked
21
B
39
A
40
C
D
41
E
42
H
G
F
I
J
43
I X .
116100 Rev. B