Commissioning - Hansgrohe Pontos AquaCycle 900 Instrucciones De Servicio

Commissioning

Note!
For commissioning, the following
installation steps must have been
carried out.
Commissioning
1. Fill stages 1 to 3 at least halfway with wa-
ter.
2. Afterwards, check all connections for tight-
ness.
3. Vent the booster pump on the service water
line. For this purpose, stage 3 must be filled
with water. Untwist the cap on the top of
the pump with a screwdriver (see figure). It
is not necessary to take off the cap com-
pletely. The pump is vented as soon as wa-
ter starts to leak. Retighten the cap.
4. Connect the connecting cable (insert the
plug into the socket).
Connection must be made at an
easily accessible socket.
5. To complete the commissioning phase,
check all functions of the water recycling
facility with the service door closed. Use
the menu Manual to do so.
Manual mode
6. Now the breaking-in phase can be acti-
vated via the control system's display.
050608
Operating instructions AquaCycle 900
Cap
Starting the breaking-in phase
1. Press the button
Auto.
2. Press the button
menu Automatic program.
3. Press the button
menu item Breaking-in phase.
4. Press the button
in phase. The display shows "Breaking-in
phase on".
5. Press the button
menu. The display now shows the mes-
sage "SmartClean". The green LED is
blinking.
Further information regarding control system
operation can be found in the chapter Opera-
tion in the operating instructions.
, to select the menu
again to select the
3 times to call the
to start the breaking-
repeatedly to quit the
EN9