Shutdown And Depressurisation; Cleaning - Sagola V 4000 Manual De Instrucciones

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 1

11. Shutdown and depressurisation

Do not use fluid which would quickly clog the filter or would often block the spray tip. Use well
filtered paints.
Air supply should be clean.
The gun is a precision instrument and it relies on good and frequent maintenance for its correct
operation. When it is carried out directly after use, the cleaning of the gun is faster and easier.
Never use metal brushes files, points or clips for dismantling.
Short duration shutdown (Less than 3 hours)
Remove the paint on the air cap with a brush and solvent. Otherwise, leave the equipment as it
is. Removing the paint will prevent the drying and clogging of the holes.
Long duration shutdwon
Depressurize the fluid systems.
Unscrew the air cap. Remove the spray tip and soak it in solvent.
Use a tip unclogging needle (Ref.30010207) of the proper size.
Flush the installation and leave it full of solvent.
Depressurisation
1. Turn off all air valves and all other air
and fluid supplies to the gun.
2. Trigger the gun into a grounded metal
waste container to relieve fluid pressure.

12. Cleaning

When work has been completed, both the spray gun or pressure pot or pump must be cleaned
with the appropriate thinner, in order to remove any remaining product.
Enter an amount of thinner.
Operate the mechanisms and spray the thinner until the application is clean. Repeat the opera-
tion as many times as may be necessary. Remove any remains of product from the gun and the
pump with a cloth soaked in thinner.
The air nozzle is a precision component. Any deformation,
especially in the air outlet orifices, may cause malfunctions
in its operation and incorrect or deficient quality spraying.
If necessary, dip the air nozzle in thinner in order to sof-
ten the remains of product or dirt. Once softened, blow the
nozzle with compressed air until any remains of product
and thinner are eliminated.
Should it be necessary to remove the air nozzle, do this
with an appropriate, soft object, with great care and avoi-
ding any marking or scratching.
ENGLISH
Tabla de contenido
loading

Tabla de contenido