Before Use - Teac A-R600 Manual Del Usuario

Speaker Connections
Connect the main pair of the speakers to the SPEAKERS
A terminals, and connect the second pair to the
SPEAKERS B terminals.
Connect the speaker cords to the speaker terminals as
shown in the following illustration.
SPEAKERS A
Insert the stripped end of
the cord into the hole in
the connector and turn the
knob clockwise to tighten
it. After tightening, check
that the cord is held
securely by pulling it
gently.
SPEAKERS B
Press the lever, insert the
stripped and twisted end
(approx. 10 mm) of the
cord, then release the lever
so that the cord is held
securely.
Note: Speaker Impedance
in case of "A"ON or "B"ON
A,B : 4~16¸.
in case of "A"ON and "B"ON
A,B : 8~16¸.
AC OUTLET
SWITCHED:
This socket switches on and off as you turn on and off
the amplifier.
Caution:
The total power consumption of the components
connected to the AC OUTLET must not exceed 100W.
Power Cord
Be sure to connect the power cord to an AC outlet
which supplies the correct voltage, as set by the voltage
selector.

BEFORE USE

Read This Before Operating
Choose the installation location of your unit carefully.
Avoid placing it in direct sunlight or close to a source
of heat. Also avoid locations subject to vibrations and
excessive dust, heat, cold or moisture.
The ventilation holes should not be covered. Make
sure there is at least 50 cm (20 inches) of space above
and at least 10 cm (4 inches) of space beside the
amplifier/receiver. Do not place a CD player or other
equipment on top of the amplifier/receiver.
Do not open the cabinet as this might result in
damage to the circuitry or electrical shock. If a
foreign object should get into the set, contact your
dealer.
When removing the power plug from the wall outlet,
always pull directly on the plug, never yank the cord.
Do not attempt to clean the unit with chemical
solvents as this might damage the finish. Use a
clean, dry cloth.
Keep this manual in a safe place for future reference.
CAUTION
Regarding Placement
(Except for U.S.A. And Canada)
To maintain proper ventilation, be sure to leave a
space around the unit (from the largest outer
dimensions including projections) equal to, or
greater than, shown below.
Left and Right Panels
Rear Panel
Top Panel
_ 5 _
: 10 cm
: 10 cm
: 50 cm