Checking The Battery Charge Level; Changing/Inserting The Tool/Collet Chuck; Switching On And Off/Setting Speed Range - Parkside PFBS 12 B6 Traducción Del Manual De Instrucciones Original

Stop charging
♦ Disconnect the USB mains adapter from the mains power supply .
♦ Disconnect the USB charging cable
CAUTION!
► Never recharge a battery again immediately after charging . There is a risk that the
battery will become overcharged .

Checking the battery charge level

If the appliance is switched on, the remaining charge will be shown on the battery LED
as follows:
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery

Changing/inserting the tool/collet chuck

♦ Press the spindle lock
♦ Turn the tensioning nut
♦ Undo the tensioning nut
♦ Remove any attached tool .
♦ First push the intended tool through the tensioning nut
appropriate collet chuck
♦ Press the spindle lock
♦ Push the collet chuck
the combination spanner
NOTE
► Use the screwdriver side of the combination spanner
screw on the mandrel

Switching on and off/setting speed range

Switching on/setting the speed range
♦ Set the On/Off switch
♦ Set the speed control
Switching off
♦ Set the On/Off swtch
│ GB │ MT
■ 78
from the charging socket
and hold it down .
until the lock clicks into place .
from the thread using the combination spanner
for the tool shaft .
and hold it down .
into the thread insert and screw the tensioning nut
.
.
to the position "I" .
to a position between "1" and "MAX" .
to the position "O" .
on the appliance .
before inserting it into the
to undo and tighten the
PFBS 12 B6
.
tight with