KENMORE ELITE 111.7269 Serie Manual De Uso Y Cuidado página 42

ICE & WATER
Problem
Icemaker is not
making ice.
Not dispensing water.
TROUBLESHOOTING GUIDE
P ossible Causes
R efrigerator was recently installed or
icemaker recently connected.
Icemaker not turned on.
The refrigerator is not connected to
a water supply or the supply shutoff
valve is not turned on.
Icemaker shutoff
1 . Dispenser icemaker optical sensor is
blocked by ice.
2. Freezer icemaker shutoff arm is
pushed all the way up by ice.
New installation or water line recently
connected.
The dispenser panel is locked.
The dispenser is not set for water
dispensing.
R efrigerator or freezer doors are not
closed properly.
Water filter has been recently
removed or replaced.
T ubing connecting refrigerator to
house supply valve is kinked.
The house water supply is not
connected, the valve is not turned on
fully, or the valve is clogged.
It may take up to 24 hours for each compartment to
reach the desired temperature and for the icemaker to
begin making ice.
Locate the icemaker on/ of button and confirm that
it is turned ON.
Connect refrigerator to the water supply and turn the
water shutoff valve fully open.
1 . R emove enough ice from bin so that the optical
sensing space is not blocked.
2. R emove enough ice from bin to allow shutoff arm to
lower from shutoff position.
Dispense 2.5 gallons of water (flush for approximately
5 minutes) to remove trapped air and contaminates
from the system. Do not dispense the entire 2.5
gallon amount continuously. Depress and release the
dispenser pad for cycles of 30 seconds ON and 60
seconds OFF .
P ress and hold the Lock button for three seconds to
unlock the control panel and dispenser.
On the control panel press the Water button.
Water will not dispense if any of the refrigerator
doors are left open.
After the water filter is replaced, dispense 2.5 gallons
of water (flush for approximately 5 minutes) to remove
trapped air and contaminates from the system. Do not
dispense the entire 2.5 gallon amount continuously.
Depress and release the dispenser pad for cycles of
30 seconds ON and 60 seconds OFF .
T he tubing can kink when the refrigerator is moved
during installation or cleaning resulting in reduced
water flow. S traighten or repair the water supply line
and arrange it to prevent future kinks.
Connect refrigerator to the water supply and turn the
water shutoff valve fully open.
If the problem persists, it may be necessary to contact
a plumber.
42
Solutions