Description; Purpose; Overview; General Power Tool Safety Warnings - Powerworks P24CG Manual Del Operario

Tabla de contenido
Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 11
EN
1

DESCRIPTION

1.1

PURPOSE

The machine is used to apply caulking material to surface,
e.g. joint sealants.
Sealing cracks to keep your home's conditioned air inside
while keeping unconditioned air outside, increasing your
home's energy efficiency.
Filling holes and cracks before painting.
Creating a moisture barrier around areas that could be
damaged by water.
Sealing cracks to keep insects from crawling inside your
home.
Applying adhesive.
1.2

OVERVIEW

Figure 1-3
Plunger
1
Plunger rod
2
Plunger rod handle
3
Lock out button
4
LED Light
5
Trigger
6
Speed adjustment dial
7
2
GENERAL POWER TOOL
SAFETY WARNINGS
Read all safety warnings, instructions, illustrations and
specifications provided with this power tool. Failure to
follow all instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
Removable cartridge
8
holder
On-board puncture
9
tool
10 Caulk tube
11 Battery release button
WARNING
WARNING
English
If parts of the machine are damaged, do not use the
machine.
If you do not have all the parts, do not operate the
machine.
If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
3.2

ADJUST THE CAULK GUN

Figure 1
1. Press the lock out button to the left, to release the plunger
rod.
2. Hold the plunger rod handle and move the plunger rod
back and forth.
3.3

INSTALL THE CAULK TUBE

Figure 2
Make sure that the removable cartridge holder is correctly
attached, and there are no residues in the removable
cartridge holder before installing.
1. Cut off the spout of the caulk tube at a 45˚ angle.
2. Press the lock out button to the left, pull back the plunger
rod handle until the plunger rod reaches the rear of the
removable cartridge holder.
3. Place the caulk tube into the removable cartridge holder.
4. Press the lock out button to the left, push plunger rod
forward to make sure that both ends of the caulk tube are
firm.
3.4

REMOVE THE CAULK TUBE

1. Press the lock out button to the left.
2. Hold the plunger rod handle and pull the plunger rod
backwards.
3. Take out the caulk tube.
3.5

INSTALL THE BATTERY PACK

Figure 3
4
WARNING
NOTE
Tabla de contenido
loading

Este manual también es adecuado para:

Cgm301

Tabla de contenido