Description; Purpose; Overview; General Safety Warnings - Powerworks PD24D220 Manual Del Operario

EN
1

DESCRIPTION

1.1

PURPOSE

The machine is used to
• drive long deck screws when you assemble a deck
• drive carriage bolts into deck posts
• drive screws into block walls and concrete
• drive screws into metal studs
1.2

OVERVIEW

Figure 1.
1 Coupler
2 LED work light
3 Switch trigger
2 GENERAL SAFETY
WARNINGS
Read all safety warnings, instructions, illustrations and
specifications provided with this machine. Failure to
follow all instructions listed below may result in electric
shock, fire and/or serious injury.
Save all warnings and instructions for future reference.
The term "power tool" in the warnings refers to your mains-
operated (corded) power tool or battery-operated (cordless)
power tool.
3

INSTALLATION

3.1

UNPACK THE MACHINE

Make sure that you correctly assemble the machine before
use.
• If parts of the machine are damaged, do not use the
machine.
• If parts are missing, do not operate the machine.
• If parts are damaged or missing, contact the service
center.
1. Open the package.
2. Read the documentation provided in the box.
3. Remove all the unassembled parts from the box.
4. Remove the machine from the box.
5. Discard the box and packing material in compliance with
local regulations.
4 Belt clip
5 Reversing button
6 Battery release button
WARNING
WARNING
WARNING
English
For your personal safety, do not insert battery before the
tool is assembled completely.
3.2

INSTALL THE BATTERY PACK

Figure 2.
• If the battery pack or charger is damaged, replace the
battery pack or the charger.
• Stop the machine and wait until the motor stops before
you install or remove the battery pack.
• Read, know, and do the instructions in the battery and
charger manual.
1. Align the lift ribs on the battery pack with the grooves in
the battery compartment.
2. Push the battery pack into the battery compartment until
the battery pack locks into place.
3. When you hear a click, the battery pack is installed.
3.3

REMOVE THE BATTERY PACK

Figure 2.
1. Push and hold the battery release button.
2. Remove the battery pack from the machine.
3.4

INSTALL THE BIT

Figure 3.
1. Push reversing button in the center position to lock the
switch trigger.
2. Move the coupler forward and hold in position.
3. Put bit straight into coupler.
4. Release the couple.
Use only impact quality bits with a locking groove.
Make sure that you attach the bit tight in the coupler before
you use the machine.
3.5

REMOVE THE BIT

Figure 3.
1. Push reversing button in the center position to lock the
switch trigger.
2. Move the coupler forward and hold in position.
3. Pull the bit straight out of the coupler.
4
WARNING
WARNING
NOTE
WARNING