Dreamtech DreamBot D10 Plus Manual De Instrucciones página 10

Routine Maintenance
EN
Clean the Mopping Module
1. Press the two release clips on the side of the water tank, remove the
mopping module, and pull the mop pad off the mopping module.
2. Pour out the water in the tank. Clean with only water and leave out to air
dry before re-installing.
Note: Do not expose the tank to the sun directly.
16
3. Clean the mop pad with water only and leave to air dry before re-installing.
Note:
• Remove the pad from the mopping module before cleaning it, and make sure
dirty water does not flow back into the water outlet to avoid clogging.
• For optimal performance, it is recommended to replace the mop pad every 3-6
months.
4. If slow water flow occurs, or the volume is not well-distributed, clean the air
hole in the cover of the water tank.
Routine Maintenance
Clean the Main Brush
Press the brush guard clips inwards to remove the brush guard and lift the
brush out of the robot.
Pull out the brush covers as shown in the diagram. Use the included cleaning
tool to remove any hairs tangled in the brush.
Note: Do not pull out the hair tangled in the main brush excessively. Otherwise,
the brush may be damaged.
Clean the Side Brush
Pull out the side brushes and use the cleaning tool to remove any hair
tangled on the brush.
Clean the Main Wheel/Universal Wheel
Note: Use a tool such as a small screwdriver to separate the axle and tire of the
universal wheel.
EN
17