Stryker Performance-PRO XT Manual De Uso página 24

R R o o l l l l i i n n g g t t h h e e c c o o t t w w i i t t h h a a p p a a t t i i e e n n t t
W W A A R R N N I I N N G G
• Always transport the cot at a lower height to reduce the risk of a cot tip. If possible, obtain additional assistance or take
an alternate route.
• Always avoid high obstacles, such as curbing, steps, or rough terrain to avoid the risk of the product tipping over.
To roll the cot with a patient:
1. Position one operator at the foot end and one operator at the head end of the cot.
2. Make sure that the litter is perpendicular when you approach door sills or other low obstacles.
3. Lift each set of wheels over the door sill or obstacle separately.
R R a a i i s s i i n n g g o o r r l l o o w w e e r r i i n n g g t t h h e e c c o o t t w w i i t t h h t t w w o o o o p p e e r r a a t t o o r r s s
Always raise or lower an occupied cot with a minimum of two trained operators. Two operators must be present when a cot
is occupied. Operators must be able to lift the total weight of the patient, cot, and any items on the cot.
W W A A R R N N I I N N G G
• Always keep hands, fingers, and feet away from moving parts. Use caution when placing your hands and feet near the
base tubes while you raise or lower the cot.
• Always follow proper hand placement on hand grips. Keep all hands clear of the red safety bar pivots when you load or
unload the cot or change cot height position.
• Always keep hands away from the foot end release handle when you raise or lower the cot with the side release handle.
To raise or lower the cot:
From the head end and foot end
1. Operator 1 (at the foot end): Squeeze the release
handle with a secure grip on the lifting bars.
2. Both operators:
2.1. Lift the foot end of the cot until you lift the weight
off of the latching mechanism.
2.2. Operator 1 (at the foot end): Squeeze and hold
the release handle while both operators raise or
lower the cot together.
2.3. Operator 1 (at the foot end): Release the release
handle when you reach the desired height.
2.4. Maintain a secure grip on the litter frame until the
latching mechanism locks into place.
EN 20
From the left side and right side
1. Check the cot to determine if the side release handle is
on the patient left or patient right side.
2. Operator 1 (on the side with the release handle): Reach
the release handle at the midpoint of the litter.
3. Both operators:
3.1. Lift the foot end of the cot until you lift the weight
off of the latching mechanism (approximately 1/
4").
3.2. Operator 1 (on the side with the release handle):
Squeeze and hold the release handle.
3.3. Raise or lower the cot.
3.4. Operator 1 (on the side with the release handle):
Release the release handle when you reach the
desired height.
3.5. Maintain a secure grip on the litter frame until the
latching mechanism locks into place.
6086-209-005 Rev AA.0