Manitowoc CNF201 Manual De Instalación, Operación Y Mantenimiento página 21

Section 4
15. Remove three thumbscrews, then remove bin cover.
16. Remove agitator bar and ice breaker on CNF202.
NOTE: Bar must be reassembled by inserting front edge into
the paddle wheel, then lowering the back edge (rounded
90 angle) to prevent water leakage into the compressor
compartment.
CNF201 - Remove Thumbscrew &
Agitator Bar
CNF202 - Remove Upright Agitator
& Agitator Bar, Then Ice Breaker
Thumbscrews, Bolts & Breaker Bar
17. Remove ice deflector.
A. Remove the two thumbscrews.
B. Lift the ice deflector out.
Part Number: 000015202 Rev 01 07/22
Remove Thumbscrews
Remove
Wingnuts
18. Remove ice dispensing wheel by lifting straight out.
19. Remove the water reservoir cover.
A. Push up on cover to snap off.
20. Mix a solution of descaler and warm water. Depending
upon the amount of mineral buildup, a larger quantity
of solution may be required. Use the ratio in the table
below to mix enough solution to thoroughly descale all
parts.
Solution Type
Descaler 1 gal. (4 l)
21. Use the descaler/water mixture to descale all
components. The descaler solution will foam when
it contacts lime scale and mineral deposits; once the
foaming stops, use a soft-bristle nylon brush, sponge or
cloth (NOT a wire brush) to carefully descale the parts.
Soak parts for 5 minutes (15 - 20 minutes for heavily
scaled parts). Rinse all components with clean water.
Do not pour descaler or sanitizer solutions into the bin.
The solution will leak out of the front of the bin and into
the compressor compartment.
Maintenance
Water Mixed With
16 oz (500 ml)
descaler
Caution
21