HTW SMART PLUS -TV-030SMPLUS Manual De Usuario E Instalacion página 16

Methods of installation
Note : Please ensure to use the accessories provided along with the product to
install this water heater. The heater cannot be hung on the support until it
has been confirmed to be firm and reliable. Otherwise, the heater may
drop off from the wall, resulting in damage of the heater, even serious
accidents. When determining the location of the bolt holes, it shall be
ensured that there is a is a clearance not less than 0.2m on the right side
of the heater. This may be required during maintenance of the heater.
This water heater shall be installed on a solid wall. If the strength of the
wall cannot bear the load equal to two times of the total weight of the
heater flldl fully with water, it is then necessary to install a special support.
After selecting a proper location, determine the positions of the two holes
used for expansion bolts with hook (200mm). Make two holes in the wall
with the corresponding depth and size matching the expansion bolts
attached with the heater, insert the bolt, turn the hook upwards, tighten the
nuts to fix firmly, and then hang the water heater on it (see Fig.3.).
Install the supply socket on the wall. The supply socket should be 3 pins,
single phase,230V/16A.It is recommended to place the socket on the right
side above the heater. The height of the socket to the ground shall not be
less than 1.8m (see Fig.4).
If the bathroom is too small, the heater can be installed at another place.
However, in order to reduce the pipeline heat losses, the installation
position of the heater shall be as near as possible to the bathroom.
Expansion bolt
(with hook)
(Fig.3)
13
ELECTRIC
WATER HEATER
SMART PLUS